View Single Post
 
Old 10-12-2009, 11:49 AM
2152hq 2152hq is offline
Member
 
Join Date: Sep 2005
Posts: 7,727
Likes: 1,633
Liked 9,099 Times in 3,366 Posts
Default

Just put an over shot wad in place and then glue into position with a bit of common cheap window caulk. A small dab placed down onto the top of the overshot wad and then pressed down on it with your thumb and twist it around. It will spread it around and into the edge of the wad and shell wall. Let them cure over nite.

The caulk will disentegrate upon fireing and the shell casings last longer cause you never crimp them.

They may start to tear at the very end a bit after a few fireings but you can trim them back. They will probably burn out at the base wad before you get all the way back to the length they would have been had they been folded/crimped.

Gives you more room for powder,wad & shot too because you don't have to allow for the folds in the case.

Just buy a small (8oz?) handy tube of the caulk. Cheaper the better.
Reply With Quote