Von FM
I have tried both Dillon AccuCrimp and the Profile Redding Crimp and start out light and work my way heavy and I get the same results as show in the pic.
I checked my RCBS dies, and the seat die which I assume is also the crimp die is marked "Seat 85".
I might test this one tomorrow. my goal is to just roll the edge slightly to improve feeding so I get more use out of my brass.
my cylinder does have a light chamfer job by the gunsmith but I need help on the bullet end.
thanks in advance
Last edited by SW CQB 45; 07-18-2010 at 01:14 AM.
|