There have been some reports of the laser not being tight on the frame from the factory. Field strip it and check the very small allen screw on the centerline of the frame. If that is tight then you need to double check the laser sight. At 7 yards the red dot should be resting on the top of the front sight when sighted properly. If not, use the allen wrench provided and make the adjustment as prescribed in the manual. There is no magic, if the sights and the dot line up then the bullet will be there shortly thereafter. At longer distances the dot will be higher than the iron sight picture and inside of seven yards the dot will be lower. That is due to the angle of the laser not being parallel with the sights. Theoretically, if you want the laser to be parallel you will have to sight it in to be about an inch and a half (more accurately the distance measured from the center of the barrel to the center of the laser lens) below the sight picture at 25 or more yards. That in mind, expect that you will always hit 2 inches higher than the dot at close range.

Good luck