Quote:
Originally Posted by Citoriplus
I believe he's saying that polishing the hammer face like that will make manual cocking, pulling the bolt back with the charge handle, a bit smoother/easier.
It should also allow it the bolt to cycle a little easier/faster because of the reduced resistance on the bolt when its ejecting empties.
It could be the answer to solving the FTF problem some have had when using low velocity or target ammo.
|
That makes sense.
I would just caution folks not to go hog wild on these parts. I doubt S&W has used top shelf parts considering the general low cost of the rifle. These parts are only case hardened. I realize this isn't a sear surface so material removal isn't going to cause a catastrophic failure here.