View Single Post
 
Old 06-30-2011, 05:06 AM
bmcgilvray's Avatar
bmcgilvray bmcgilvray is offline
SWCA Member
 
Join Date: Jan 2006
Location: Texas
Posts: 3,353
Likes: 10,447
Liked 6,092 Times in 1,249 Posts
Default

Some mediocre results from efforts to put the loads on paper, burning up the remainder of the test loads. While it was very windy at the range, these targets represent the best of an embarrassing lot. The rest were best forgotten.

The 2-inch Model 10 and 5.4 grains of Unique. Shot the left target at 10 yards in single action mode . Also showing a spontaneous 25 yard effort, also shot single action. It was the only revolver that was unlimbered at 25 yards. I'd thought to make a bit longer effort with the snub in order to show it off. Didn't work out and there wasn't enough ammo for a second attempt. This was a 6-shot attempt. Note the merest hit of a bullet clip on the right side of the target.


Here's the 4-inch Model 10 HB with "The Load." 10 yards, both single action and double action.



The 8 3/8-inch and a single action group (group you say?) at 10 yards with the 2400 load.



It's a sure bet that these weren't target handloads. The revolvers didn't seem to be excessively leaded by visual examination and proved not to be difficult to clean.

It is possible to equal the Buffalo Bore +P 158 grain factory loads by reaching back to data in older handloading manuals but I'd be sorely tempted to load with Buffalo Bore for self defense purposes since such handloads can't be pressure tested. These loads were worked up but they still could be too much of a good thing for any type of long term use.

Perhaps these loads would have some hunting application but it would be easier to leave the .38 Special at home and just go with the .357 Magnum.
The Following User Likes This Post: