View Single Post
 
Old 01-09-2012, 09:02 PM
snubbiefan snubbiefan is offline
Member
 
Join Date: Apr 2011
Location: Southern Mississippi
Posts: 1,861
Likes: 23
Liked 348 Times in 203 Posts
Default

It's not the bores themselves that should be of any concern, but the end-shake. We all know that every time we fire the gun the interaction between the cylinder and the yoke-rod "clash", which eventually causes end-shake. Any Smith revolver will suffer this condition under enough shooting. I just think the aluminum components can't stand-up to it like the SS, or carbon steel components can. I have an old aluminum cylinder and a yoke tube that has been stretched twice over it's lifetime and has an end-shake around .008 now even after the rod has been lengthened twice.

They are not likely to explode, but the surface areas in the yoke-tube to cylinder deserve much closer attention to routine cleaning and lubrication than a fully steel gun.

Last edited by snubbiefan; 01-09-2012 at 09:05 PM.
Reply With Quote