Quote:
Originally Posted by DocGlock
On my Shield, a 1/16" is too small, and a 5/64" is too large.
|
The same 1/16" I used on my 1911 works on the Shield. There is about 15 degrees of play in it but it did loosen the setscrew pretty easily. In my case, I'm guessing a higher quality allen wrench would eliminate some of that free play.
While there did look to be red Loctite on the threads it broke free easier than the one on my 1911 did.
P.S. Just measured the wrench and it is .060, which is just a tad under 1/16.