These are the original stocks that came on my 586 project magnum. It was a 6" no dash with a bubba trigger job and a lot of finish wear. Every sharp edge on the stocks had been rounded over and the speedloader cut out had been buggered up. I fixed the terrible push off with a new trigger and then I sent the gun off to the factory for the recall work. I had them do some custom work while it was there, putting on a 4" tube and bead blasting with fresh blue. While it was away I took the round over job on the stocks to the extreme. I was going for a J frame target look. I also re-cut the lines on the speedloader cut out and gave them a tung oil finish.
Before
After
__________________
Regards,
Guy-Harold Smith II
Last edited by Smith357; 05-11-2012 at 04:40 PM.
|