View Single Post
 
Old 10-20-2012, 01:21 AM
1fly2ty 1fly2ty is offline
Member
 
Join Date: Nov 2010
Location: Nampa, Idaho
Posts: 206
Likes: 46
Liked 57 Times in 41 Posts
Default

snuf,
Just received mine today, the same one you have pictured! well made and relatively easy to use. The commenting about the red loctite are correct but I chose a different way to deal with it, I have a commercial grade heat gun, I simply heated up the rear sight a little and the screw came loose and it took little effort to change the rear! Now the front was a bit more difficult, had to remove bottom block and make shims to get proper height but once I got it st up it was a breeze to push it out and then install the new one. I went with the Tru-Glo TFO's and I sure like them. I also got an extra set of blocks in case I have to work on other handguns, like XD's. Good tool ! and quick service I sent the money order off las week on Thursday and received the tool today.

Last edited by 1fly2ty; 10-20-2012 at 12:29 PM.
Reply With Quote