View Single Post
 
Old 12-17-2012, 08:22 AM
FloridaFlier FloridaFlier is offline
Member
 
Join Date: Mar 2011
Location: Naples, Florida
Posts: 324
Likes: 163
Liked 190 Times in 89 Posts
Default

Thanks again to all. I plan to check the nearby range and auto tire shops. If I can get a good source of lead, I'll give casting a try.
Side note: I tried to measure the barrel of a .44 special, but could not get a clean measurement because the lands on one side are opposite the groves on the other. I was able to get clean numbers for the cylinder face. As my revolvers are all 1980 to present S&W's, that's all I need, right? Then I would look to buy or make soft bullets that are about .001" more diameter than the cylinder face. Am I saying that right?
Reply With Quote