View Single Post
 
Old 06-09-2013, 12:34 PM
RPK RPK is offline
Member
 
Join Date: Jan 2011
Location: Alexandria, VA
Posts: 62
Likes: 17
Liked 17 Times in 9 Posts
Default

Quote:
Originally Posted by rettxpo View Post
Just take it slow and easy and it'll be fine. I started with using a file but then switched to my dremel. I used a cutting disc but used the flat part on top instead of the edge to get a smooth surface. It ended up much easier than the file method and gave me a smooth even surface. Just take a little off each time and check it.
I may take it to a buddy of mines house and try it, he's not a gun smith per say but he's good with this kinda of stuff and makes his own rifles. I'm currently renting and don't have a work bench
Reply With Quote