Thread: M&P 10 - Damage Industry Rails
View Single Post
 
Old 07-07-2013, 03:09 AM
rojodiablo rojodiablo is offline
Banned
 
Join Date: Sep 2011
Posts: 1,759
Likes: 613
Liked 1,190 Times in 626 Posts
Default
Quote:
Originally Posted by cclark89 View Post
please be kind with me on this...I'm new...

I purchased the Damage Industries rail for my M&P 10.

AR15/M16 1913 Rail Handguard Assy, Mid length | Damage Industries

I got the stock handguard off no problem. After that though, I'm a little confused how to proceed in getting the new rail on.

While I don't want to be too rough getting the rail in there, my attempts so far haven't been productive.

From the one picture that seems to be floating around of this rail on an M&P 10, I can't quite tell if the person removed the handguard cap.

Is there anyone out there that has put this rail on? Does the Handguard cap have to come off? Gas Block? Maybe the rail even goes over the cap? Step by step instructions would be very preferred.

When I purchased I was really under the impression it was going to be more of a drop-in type scenario. This may likely mean I'm making this harder than it needs to be.

Thank you for your help.
You answered your own question, I am pretty sure.
Most quad-rails tend to lock down over the delta ring at the front of the rifle, whereas a 2 piece drop in will lock in under the delta ring. It should be a pretty straightforward installation for you.
Reply With Quote