I found my solution, took it to my local smithy. 10 seconds, it was out. I got the original pin back in ok, tight but went in. I was afraid of getting it started and losing it across the room somewhere, but didn't happen.
I also put a drop of blue locktite on the end of the gas tube at the ring area. Didn't care for the loose fit and was concerned about blow by. The smith said it wouldn't hurt anything but not to use much.
I imagine if there is any blow by it will burn out the locktite in short order anyways.
Last edited by Jessie; 09-14-2013 at 02:08 PM.
|