View Single Post
 
Old 02-19-2014, 10:58 PM
49willys 49willys is offline
Member
 
Join Date: Feb 2014
Location: dry side of Oregon
Posts: 38
Likes: 5
Liked 18 Times in 9 Posts
Default

After reading through this thread,I decided,for myself of course,that spending money on one of those little tiny pieces of metal is not going to happen.So I went out to the garage and found a piece of steel that was the same thickness and made one myself.All it took was a dremel with the cut off wheel and a small flat file.I held onto the piece with a small vice grip,I dont have a bench vice but think that it would work better.About 45 minutes later I came up with this.The factory piece is on the right.A bit crude looking,but it works perfectly.
Reply With Quote