Thank You everyone for the advise, kind words, and support!!!!
Spent some of the day in the shop today and yesterday.
I set everything up to drill the hole for the locking bolt Friday night, but had to run into my friends shop for the .043 carbide bit I purchased to use on my last .32s replacement hand (that's a whole nother story, I frame, broken hand)...
Anyway, drilled that hole.... Long story short, hind sight being what it is, should've put a plug in the locking bolt housing and gone all the way through. Wound up with the hole .020 off on the other side.
So today was spent making pins to fill that hole, then re-drilling it all the way through from the other side....
I'll have to open the recess up in the barrel where I relieved for the holes to make it look "right", but all and all, turned out well!!
This is the good side, once I touch things up I'll throw up pics of both sides.