Quote:
Originally Posted by armorer951
Any reliability issues in single action?
Some side to side play in the cylinder is normal and necessary. I'm assuming your primer hits are in the center of the primer pocket, more or less.
What about end shake on the yoke, did you check for that? The two crowned sideplate screws can get switched and this can cause problems. The front sideplate screw is fit to the button on the yoke stem.
|
Since it has the bobbed hammer, I can only shoot it in single action if I carefully pull the hammer back. i have done that on several occasions just to check, and it fires every time.
I ordered and have already replaced all the sideplate screws including the yoke. Very little yoke shake. (Hopefully I checked it correctly)
The primer hits are pretty much centered.
I'll probably put it all back together and take it out to the range to see if I can identify any specific oddities.
Any interest in looking at it?