Thread: K32 build....
View Single Post
 
Old 02-04-2017, 07:45 PM
steelslaver's Avatar
steelslaver steelslaver is online now
US Veteran
 
Join Date: Oct 2013
Location: Central Montana
Posts: 13,625
Likes: 12,742
Liked 39,091 Times in 9,966 Posts
Default

I don't think so. It is done all the tie with bearings etc. Plus with the method I taked about the liner would be beefier than the shroud piece, unlike the thin barrel liners most use. Thin liners would work poorly in a revolver anyway because of the bevel in the forcing cone making the liner horrbily thin in a critical blast area. Plus you would only need .0005 interference to make it very tight.

Last edited by steelslaver; 02-04-2017 at 07:47 PM.
Reply With Quote
The Following User Likes This Post: