In regards to the gunsmithing I needed done. I hopefully tackled the problem by myself. I want to give a huge thanks and shout out to BLUEBELLYYANKEE along with W.E.G for their wonderful Utube videos and tutorials on how to disassemble a 3rd generation auto. Also, a thanks goes out to 18DAI for his wisdom and Walter O for his suggestions.
I started by pulling the firing pin on a CS9 since it had a de-cocker on one side. With a proper punch and a good light everything that was shown in the tutorials stood out. It turned out easier than I had expected. Then came the DAO 457D I have that had the weak primer strikes. This one took a bit more patience but I was successful. This pistol was caked with grease in the firing pin channel. the grease was hardened on the spring. I also wound up doing a 3913LS also just because I did get the hang of it.
Off to the range tomorrow and I am expecting a good day!
MET