View Single Post
 
Old 03-14-2017, 09:36 AM
Crmcdm Crmcdm is offline
Member
 
Join Date: Aug 2015
Posts: 23
Likes: 4
Liked 8 Times in 6 Posts
Default

I too watched the various videos available from Apex and others, and they served me well. I did it without a sight pusher- used brass and steel punches and a hammer and was able to get sights off. They are definitely a little stubborn. Pre-soaked with breakfree (I think), and touched a soldering iron on the rear sight retention screw to kill loctite. Not sure that was needed. Bang out sights from left to right (toward the ejection port). Some said you could go either way, and the dovetail looks that way....but I know left to right works. The rest is well shown in the videos....and I used the opportunity to change out my sights. I love the results. Good luck!

Sent from my SM-G920V using Tapatalk
Reply With Quote