There are a lot of dimensions on this site.
Smith
Here on some S&W dimensions with some not on that page. I took these because of another thread wishing for the near impossible K frame 44 mag.

Measured with digital calipers. May be off a .001 or so here and there. Did not spend all day at it. I do know that frames and cylinders vary a few thousands.

J frame using a 36-1 and a 640-1
window height 36-1 1.34 640-1 1.342
window length 36-1 1.631 640-1 1.736
cylinder OD 36-1 1.325 640-1 1.375
Radius chamber center from cylinder center. .42
ratchet OD .426 with a .012 dip for rims
Barrel shank at forcing cone .452

K frame 19-3
Window height 1.482 length 1.809
cylinder OD 1.455
chamber centers from cylinder center .456
ratchet OD .56 and dip of .043 for rims
barrel shank at FC .504 side to side small flat at btm

L frame 696 and 69
Window height 696 1.598 69 1.68
length 696 1.814 69 1.82
Center of cylinder to center of chamber .51
ratchet od .528 with .025 dip for rim
FC barrel od 696 .524 69 .601

N frame 57-1 and a model 25-5 cylinder
window height 1.736 length 1.88
cylinder od 1.7
center to chamber center .551
ratchet OD .56 with a .01 dip from rim on model 25-5 for rim clearance
Barrel shank at FC .626

Here are some other interesting numbers on cylinders

J frame 357 chamber walls .046 (offset cuts) between .095

K frame 357 outside .75 (-.040 lock cut), between chambers .70

L frame 44 mag outside wall .045 (offset lock cut) between .122

N frame 45 colt outside wall .0625 (-.034 lock cut) between .055

N frame 44 mag outside wall .076 (-.034 lock cut) between .079

If a guy could get a 5 shot 45 colt cylinder (or a blank) it would be possible to have a 5 shot N frame 45 colt with cylinder walls considerably thicker than those of a model 69 44 mag (.02 thicker on outside wall and between chambers than model 69's outside wall) and have offset lock cuts and run real magnum pressures around 36,000 psi. The impulses to the frame would be no more than a 44 mag firing the same weight bullet. I can dream, but my 45 colts running around 20,00 psi are really all I need. Just an observation from these dimensions.