Quote:
Originally Posted by socal s&w
If it is the cylinder release, this may sound very basic, but I would check not only the tightness of the cap screw, but before that also make sure that the piece is sitting in the slot properly. Sometimes it may appear that it is completely seated when in fact it is not. Upon installing the release, it usually needs to be pushed slightly foreward to seat properly.
|
Where do I find step by step direction to do this?.I bought a used 638-3 airweight 1 1/2 yrs old.
I put roughly 100 rounds down range of mixed bullet types and weight, came home to clean it noticed the cylinder release was loose tightened the screw tight but still wobbles N/S...any other advise would be greatly appreciated.