So far my Shield 45 has been wonderful and exceeds my expectations. I have shot factory 230 RN FMJ and Extreme 200gr SWC plated with not a single issue.

However the other day I picked up some Berry's Target Hollow Points, 200gr bullets. Berry's lists max OAL at 1.275, I loaded to 1.1950, they dropped in the Lyman case gauge easily, they fired in my friends Ruger 1911 as well as another 1911.

Attempted to chamber in the first round into my Shield and the slide did not go into full battery and jammed pretty tight. I ejected the round, inspected and tried another with the same result. Looking closer there was noticeable scuffing on the edge where the tape of the nose meets the straight wall of the side. I thought maybe there could have been too much crimp and it expanded the bullet at this point being a plated bullet but I measured and they were still .451 at the edge. I pulled the barrel from the shield and sure enough they don't drop in, I tried another dummy round at max COL and kept seating deeper, but even then when I got it flush with the hood of the barrel it didn't 'plunk' in and it was pretty short at this point.

These reloads shot fine out of my 625 45acp revolver.

It's just not making sense to me on the 'why' part, a little help please on this issue.
Thanks
Karl

**I want to thank the kind folks at Berry's for the quick follow up phone call to respond to my email. Impressive customer service for sure. Thank you Jason from Berry's Bullets!**