View Single Post
 
Old 04-13-2017, 08:32 AM
Fishinfool's Avatar
Fishinfool Fishinfool is offline
Member
 
Join Date: Feb 2011
Location: Central PA
Posts: 4,550
Likes: 8,201
Liked 11,436 Times in 3,018 Posts
Default

Make sure the decapper pin is straight in the die when you tighten it up. You could remove the pin, and lay it flat on a table to see if it is bent. If so, a few light taps with a small hammer should straighten it. It pays to have a couple spares, as they do break. If the retaining set screw / nut keeps loosening up, a drop of Locktite blue might help.

Larry

Last edited by Fishinfool; 04-13-2017 at 08:34 AM.
Reply With Quote
The Following User Likes This Post: