Quote:
Originally Posted by fredj338
Something else to consider. The bullet now has plating binding it to the case. This could increase pressures as the bullet has to break that seal. Kind of like gluing it in place.
|
Not too sure about that, right at the crown on the casing you can see a little bit of copper at the crimping area, which actually means the solution could not plate there because it was sealed with a glue or clear sealant.
I know what you are describing, but in THIS case seems to be ok..
i plated two different threads once and realized they should have been connected, now they dont thread.. need a good brass brush to fix that i think, but this looks decent..
the tank was cold when i did this and some are cloudy, i was just doing it as an initial experiment. hopefully they fire.. i will find out eventually..