Quote:
Originally Posted by policerevolvercollector
The bore is in very good condition. I'm going to shoot it just like it is after I clean it internally.
|
You know what I think I would try? Remember the post a bit back about the torque pounds of various penetrating oils and the simple mixture of 50/50-ATF/Acetone resulting in the lowest? I would get a quart of each, mix in a clean covered container and soak that revolver for a week before I did anything else (after pulling the grips). Sure be a cheap initial run at cleaning it up. I don't think it could hurt anything and it would be interesting to see if it helps with the finish issues.