thanks for the intell.
I will not chamfer...but stone flat.
I checked the hammer while holding the trigger ...... the hammer is not in contact with the rebound slide.
also, the firing pin floats upon full contact with the inside of the receiver.
I would also guess that the tolerance of the rounds could be a factor. I have 3 rounds to test the launcher....they use a .38 Short Colt primed brass as the ignition source.
two of the primers are set deeper than the third. I asked to see the cases of the rounds that misfired.....but they have not surfaced.
thanks again
__________________
if you're gonna be a bear...
|