View Single Post
Old 05-18-2017, 06:04 PM
opaul's Avatar
opaul opaul is offline
US Veteran
Join Date: Nov 2011
Location: Central NC
Posts: 1,924
Likes: 5,131
Liked 3,073 Times in 778 Posts

Originally Posted by Richard Simmons View Post
I like the design of your knife, particularly the profile of the blade. How did you heat treat it?
Sorry for the delay. I did not heat treat it. Reason being, and I'm sure there are many different opinions, that when I ran the edge of a file over the steel it skated across. I was also careful not to overheat the steel when I cut out the shape.
It takes and holds an edge well. I just made the bottom one in the photo out of the same saw blade.
But I am in the process of getting a propane forge and study up on metallurgy
Added second picture with the leather sheath I made for the smaller knife.
Attached Thumbnails
Circular Saw Blade Knife-last-two-knives-may-16-jpg   Circular Saw Blade Knife-going-away-knife-gift-alec-jpg  
T&P 2016-2024 and Beyond!!

Last edited by opaul; 05-18-2017 at 06:13 PM.
Reply With Quote
The Following 5 Users Like Post: