View Single Post
Old 07-16-2017, 02:11 PM
SP45 SP45 is offline
Join Date: Feb 2004
Location: Stoutland, Mo.
Posts: 228
Likes: 0
Liked 19 Times in 6 Posts

as I recall factory standard back in the 80s was .005 to .010. I know when they tried to get it to tight down to .002 they had problems with cylinder bind. I have seen as high as .015. I have also seen where it is different depending on which side you measured from so obviously the barrel shank was not cut straight, that is if the cylinder was turning true.
Reply With Quote