View Single Post
 
Old 09-13-2017, 10:48 AM
iPac's Avatar
iPac iPac is offline
Member
 
Join Date: Mar 2015
Posts: 720
Likes: 813
Liked 775 Times in 330 Posts
Default

Quote:
Originally Posted by steelslaver View Post
All the same thread .670 x 36 to the inch. They are torqued the same as the pinned barrels. Have taken off and installed barrels on both pinned and un pinned. If you can figure out the spot for the pin it is just narrow shallow groove across the tread area that allow the pin to pass over. It doesn't actually hold anything firmly.
During a discussion with Frank Glenn, he informed me that the barrel pin in S&W revolvers hasn't served the purpose of actually keeping the barrel locked tight for quite some time. Meaning way back in the day the pin actually did that job, but during more modern times the pin was of little importance.
Reply With Quote