Thread: SW 69 = failure
View Single Post
 
Old 10-12-2017, 07:45 AM
steelslaver's Avatar
steelslaver steelslaver is offline
US Veteran
 
Join Date: Oct 2013
Location: Central Montana
Posts: 13,625
Likes: 12,742
Liked 39,091 Times in 9,966 Posts
Default

The ball not being totally centered.causes it to exert a inward pressure on the yoke. If it was bottomed out in center of V notch it would exert less inward pressure. Think of it as a ramp that happens.to end with a V. As other have said it was designed that way. If it contacted other side of the V it would start to press ball in and out on yoke.

It works and works well. Better than a lug in a small hole over an inch out on the end of.a skinny ejector rod that rotates and can't have any pressure on it or it will effect effort needed to turn cylinder.
Reply With Quote
The Following 9 Users Like Post: