View Single Post
 
Old 04-23-2018, 09:22 AM
LoboGunLeather's Avatar
LoboGunLeather LoboGunLeather is offline
US Veteran
 
Join Date: Nov 2008
Location: Colorado
Posts: 7,518
Likes: 19,273
Liked 32,340 Times in 5,474 Posts
Default

Now, more seriously, a couple of suggestions:

1. Try to eliminate sharp corners and edges (toe-end of holster at stitch-line, upper edge of slide shield). These can cause serious comfort issues in use.

2. For IWB carry you may want to consider reversing your pattern and making the holster with the rough (flesh-side) out and top (smooth-side) in. The rough texture can help maintain carry position in the waistband, and the smooth side is easier on the handgun finish during use.

3. You probably already understand that the attachment point(s) for your belt clip will have to be completed prior to final assembly and stitching of the holster body.

4. IWB carry always exposes the holster to moisture (perspiration from the body). The leather should be thoroughly sealed to minimize moisture absorption (water-based acrylic lacquer, such as Resolene brand, will do a pretty good job).

5. Because of the moisture issue be sure to remove the handgun from the holster after each day of use, wipe the gun down with an oily rag, store the holster separately in an area having good air flow to permit evaporation of residual moisture.

Best regards.
Reply With Quote
The Following 6 Users Like Post: