Model 29-3 unlocking Problem
I'm to agree with Mike0251. With too much end shake would allow the cylinder stop not to make full contact with the cylinder notch not to make full contact with the cylinder bolt. Check cylinder gap and add shims to make it tighter, this would help the bolt make full contact with the cylinder notch. It's not hard to DIY. Just don't loose the little spring in front of the bolt. I'd also install a stronger bolt spring while I'm at it. No springs will fly out if you remove the slide plate if you remove the side plate and gently tap the handle until the side plate comes loose. Check to see how the parts fit together and reassemble. Never FORCE anything!
|