Quote:
Originally Posted by KneverKnew
I do appreciate the effort to help. But I'm going to have to study your reply a bit to understand it better. Pictures would help, if such things are available?
|
See the collar (like a little top hat) on the right end of the extractor rod in photo below? That's what you'll need. If it's not a separate piece on your rod, whack it off on the left side of the larger diameter ridge with a dremel tool cut off wheel or a hacksaw. Dress the cut edge with file or stone it smooth and square it up on the cut end.
Slide the ext rod thru the yoke sleeve from the front,
install collar over the threaded end of the rod sticking out the back end of the yoke sleeve,
Install the ctr pin, little spring end first (the way it came out, not like in the photo, that's a TL rod and the opposite of yours) into the ext star shaft inside the cyl hole,
the large spring inside the center hole of the cyl assembly will nest against the collar as you slide the cyl forward onto the yoke sleeve all the way,
now screw the ext rod (right hand threads) into the extractor shaft inside the cyl hole,
now install the yoke in the gun.
Triple Lock extractor rod assembly shown; slightly different from all other Hand Ejector ext. rods.
Photo by Steelslaver