View Single Post
Old 08-30-2020, 02:14 PM
stansdds stansdds is offline
Join Date: Apr 2007
Location: Virginia
Posts: 3,888
Likes: 4,351
Liked 4,476 Times in 2,206 Posts

I seriously doubt that end shake shims are going to cure a lead shaving problem.

Lead shaving occurs when the chamber is not in alignment with the barrel forcing cone. This can be the result of the hand not fully carrying up the cylinder, a poor fit between the cylinder stop and stop notches, a worn ratchet, or a combination of these issues. It can also happen if the cylinder yoke is bent.
Reply With Quote
The Following 2 Users Like Post: