View Single Post
 
Old 07-25-2021, 01:48 PM
USBP SW USBP SW is offline
Member
 
Join Date: Nov 2005
Location: San Diego, California
Posts: 290
Likes: 47
Liked 159 Times in 74 Posts
Default

I have been casting bullets since the early 1970's, I too prefer iron moulds over the aluminum. There are still deals to be had for casting equipment, much like the initial bargain. My favorite moulds were made by Hensley & Gibbs, I was truly fortunate to find quite a few in the $20 to $30 price range for four cavity moulds. I've also had good results with Saeco moulds. The remaining moulds are Lyman and RCBS. Casting makes you considerably more independent, since once you have alloy, you can reproduce any load. Best of luck to you and enjoy casting.
Reply With Quote
The Following User Likes This Post: