View Single Post
 
Old 08-31-2021, 07:06 PM
WR Moore WR Moore is offline
Member
 
Join Date: Oct 2006
Posts: 4,925
Likes: 526
Liked 3,289 Times in 1,684 Posts
Default

Quote:
Originally Posted by canoeguy View Post

I'll start with a careful look at using the factory crimp die, and get a Lee trimming tool...
As someone who appreciates simplicity, I've used the Lee trimming system (cutter with interchangeable stud that controls case length-if they also make a better system now, quit reading) for decades. However, you can't really depend upon the accuracy of the trim and since Lee does regular steel cutters, they get dull with much use. It can also be most time consuming even with an electric drill/screwdriver rotating the cases.

If you are going to go this route, have a good calipher on hand and check the length of each and every case while trimming.

Last edited by WR Moore; 08-31-2021 at 07:08 PM.
Reply With Quote
The Following User Likes This Post: