View Single Post
 
Old 09-09-2021, 08:31 PM
teletech teletech is offline
Member
 
Join Date: Feb 2014
Posts: 446
Likes: 45
Liked 439 Times in 198 Posts
Default

Quote:
Originally Posted by BillBro View Post
I'll throw this out to see what advice I get, I also have HS-6, 4227, A2,5,7, and 9, H110, Vhitavuori N340, some Vectan 7.5 and 6.5, a little titegroup, and, I think that's it. If there is a better 44spl powder among them please advise. I tested some HS-6 alongside the CDE and also A5 and my gun liked neither. Of course most of my testing has been with some of the worst plated,240gr bullets I've seen and I'm glad to almost be rid of them. I really believe most of my dismal results with that cartridge has been due to that bullet. Do along the same vein I'd love to start casting so any design and mold recommendations also welcome.
I've had very good luck with Titegroup in my .44 using lightweight bullets (174gr TC). It prints a lot lower than my full house 98. Blue Dot loads but is just as accurate and a lot easier on the shooter.
Reply With Quote