FS: Here's a left handed tooled and lined belt and two unlined tooled holsers for it. One is a lightweight holster for a 7 1/2" Colt or clone, the other is a studded jockstrap for a 4 3/4" Colt. Buyer must be around 38" WHERE THE GUNBELT IS WORN (not pants belt). That's the length from the middle hole of the tongue to the buckle. $145 + $10 shipping.
Also, a left handed border tooled lefty holster for a 4 3/4" Colt or copy. $35 + $5 shipping (it's on the right in lower pic). 1ST "I'll take it" followed by PM. Shipping is to lower 48 only. Guns not included. No hammer thongs on holsters. TAN HOLSTER ON RIGHT IS SOLD!

any idea who made these?

Thanks

I made them. The long holster was my first "Cheyenne plug". Here's another pic.

I realize you mentioned Colt or copy. If you please, I would like to buy the tan holster if it would fit a Ruger OM 4 5/8" bbl .41 Mag, as I have no Colts or copies.

I would guess that the rear sight is no issue, as it would be outside the leather. So the question might be the front sight and/or square config of top strap...

Thanks for your thoughts.

Regards,

Dyson
[dysongy AT aol DOT com]

I have PM'd you in response to your PM.

Cordial thanks,

Dyson

Thanks for sending the lefty tan 4 3/4" on approval for size of my Ruger revolver.

It is a pleasure to work with you. No doubt a lefty out there has need of the patina-rich Colt/copy 7.5 inch holster and belt, assuming they are still available.

Regards,

Dyson