SOLD!!!
Selling a fantastic XM177 retro build that I just finished. Other priorities have come up and it's got to go. This is a complete upper with charging handle and bolt carrier group (BCG).
Specs:
Upper - Fulton Armory A1 with all new USGI parts and M4 feed ramps
BCG - M16 phosphate carrier with nickle boron 9310 steel bolt and chromed firing pin
Barrel - Brownell's 12.7 inch retro pencil barrel with chrome lining chambered in 5.56 NATO. Correct non F-marked front sight without bayonet lug and Brownell's XM177 flash hider with grenade ring. 1/7 twist. Feed ramps blended to match upper receiver. With flash hider the barrel measures just over 16 inches long. If you pin and weld this flash hider then you can put any stock with this upper that you want. If you don't pin and weld the flash hider then you have to use it on a pistol lower or register it as a Short Barreled Rifle.
Handguards - Vintage 6 hole units with aluminum liners. Not sure of make but I had to clean them up and they fit nice and snug compared to others out there.
Comes with one Brownells milspec 20 round magazine.
It has been function fired with about 25 rounds of FMJ and soft point ammo. Function was 100%.
Asking $675 shipped. If you want the retro XM177 buttstock and A1 pistol grip shown on the lower it will be $35 more. But remember, you have to go SBR or pin and weld if you want to use the stock.
PM with questions if I wasn't clear on any details.
Payment options: USPS money order, personal check, or PP F&F.