Smith & Wesson Forum

Advertise With Us Search
Go Back   Smith & Wesson Forum > Ammunition-Gunsmithing > Ammo

Notices

Ammo All Ammo Discussions Go Here


Reply
 
Thread Tools Display Modes
  #1  
Old 01-28-2009, 12:24 AM
coleman coleman is offline
Member
 
Join Date: Jan 2006
Posts: 27
Likes: 0
Liked 0 Times in 0 Posts
Default

http://gunsandammomag.com/cs/Satelli...inchester+PDX1

Hot off the R&D loading benches of Winchester is the new Bonded PDX1 ammo, designed to satisfy the FBI ballistic protocols.

The "bonded" in the name should be a clue. The lead core is essentially welded to the jacket, so when the hollowpoint expands the two remain attached. Having punched more than a few bullets through auto glass in ballistic testing, I can tell you that jacket-core separation is a bad thing for terminal performance.

The hollowpoint is a six-petaled gaping maw of an opening that promises lots of terminal ballistic performance, and its expansion does not disappoint. Adding reliable feeding to the round is a nickel-plated case or cases, as the PDX1 line is going to start out in six loads in four calibers.

Testing new ammo is tough when you have to practically snatch it off the R&D loading benches to test. That's how early in the process G&A, and my test guns, had sample ammo. In fact, the only ammo available in any quantity for our deadline was .40 S&W. But it did not disappoint: I tested it in three different pistols, and the velocities were right up there. In the gun with the 4.5-inch barrel, the 180-grain bullets clocked 977 fps. Out of the 4.75-inch barrel, they managed a dead-even 1,000 fps, and from the 5-inch gun, 1047 fps. Yowza! That means a Power Factor of 188, making Major even in the dinosaur days of IPSC. You'd really have to be grumpy to refer to such a load as "Forty Short-and-Weak."

Performance was everything you'd expect of a load the FBI is receiving as I write this: Full expansion, with the average of the first five round being .615-inch, and full FBI penetration, averaging 15 inches of gelatin. This is not ammo for the faint-of-heart. Launching a 180-grain bullet in the close vicinity of 1000 fps takes work, and your hand will realize that. But if it is performance you want, this ammo delivers.

The plan for ammunition at the moment is this: .38 Special +P (130 grains), 9mm+P (124 grain and 147 grains), .40 S&W (165 and 180 grains), and .45 ACP (230 grains). Really, what doesn't that cover?
Reply With Quote
  #2  
Old 01-28-2009, 12:24 AM
coleman coleman is offline
Member
 
Join Date: Jan 2006
Posts: 27
Likes: 0
Liked 0 Times in 0 Posts
Default

http://gunsandammomag.com/cs/Satelli...inchester+PDX1

Hot off the R&D loading benches of Winchester is the new Bonded PDX1 ammo, designed to satisfy the FBI ballistic protocols.

The "bonded" in the name should be a clue. The lead core is essentially welded to the jacket, so when the hollowpoint expands the two remain attached. Having punched more than a few bullets through auto glass in ballistic testing, I can tell you that jacket-core separation is a bad thing for terminal performance.

The hollowpoint is a six-petaled gaping maw of an opening that promises lots of terminal ballistic performance, and its expansion does not disappoint. Adding reliable feeding to the round is a nickel-plated case or cases, as the PDX1 line is going to start out in six loads in four calibers.

Testing new ammo is tough when you have to practically snatch it off the R&D loading benches to test. That's how early in the process G&A, and my test guns, had sample ammo. In fact, the only ammo available in any quantity for our deadline was .40 S&W. But it did not disappoint: I tested it in three different pistols, and the velocities were right up there. In the gun with the 4.5-inch barrel, the 180-grain bullets clocked 977 fps. Out of the 4.75-inch barrel, they managed a dead-even 1,000 fps, and from the 5-inch gun, 1047 fps. Yowza! That means a Power Factor of 188, making Major even in the dinosaur days of IPSC. You'd really have to be grumpy to refer to such a load as "Forty Short-and-Weak."

Performance was everything you'd expect of a load the FBI is receiving as I write this: Full expansion, with the average of the first five round being .615-inch, and full FBI penetration, averaging 15 inches of gelatin. This is not ammo for the faint-of-heart. Launching a 180-grain bullet in the close vicinity of 1000 fps takes work, and your hand will realize that. But if it is performance you want, this ammo delivers.

The plan for ammunition at the moment is this: .38 Special +P (130 grains), 9mm+P (124 grain and 147 grains), .40 S&W (165 and 180 grains), and .45 ACP (230 grains). Really, what doesn't that cover?
Reply With Quote
  #3  
Old 01-28-2009, 04:55 AM
flop-shank flop-shank is offline
US Veteran
 
Join Date: Sep 2006
Location: The Rust Belt Buckle/Mich
Posts: 2,382
Likes: 0
Liked 41 Times in 32 Posts
Default

Revolvers.
Reply With Quote
Reply

Tags
ipsc, winchester


Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Winchester PDX1 130gr 38+P GMK Ammo 19 04-28-2014 05:28 PM
Winchester PDX1 Ammo? Steve in Vermont Ammo 8 02-21-2011 08:25 PM
Winchester PDX1 410 Mod10 Firearms & Knives: Other Brands & General Gun Topics 4 08-08-2010 04:04 PM
Wal Mart has Winchester PDX1 Smokester653 Ammo 4 11-30-2009 12:43 AM
Winchester .38 Special PDX1 +p IndianaDave Ammo 7 04-12-2009 04:57 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 04:29 PM.


Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)