smith-wessonforum.com    Main Page  Hop To Forum Categories  Ammunition    Washed a speed strip full of .38's...
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
  Login/Join 
Member
Posted
well...actually my wife did. I had a speed strip loaded with Winchester 158 LSWCHP +P's in my back pocket when I went out last night and forgot to take them out when I got home. My wife picked them up and ran them in a load of laundry this evening. I realized it when I went looking for it today. Pulled them out just before the rinse cycle was about to start filling.

So...I won't use them to carry anymore but do you think they will be OK to shoot or is there too big of a chance of a squib and a stuck bullet?
 
Posts: 667 | Location: Idaho Falls, Idaho | Registered: 20 April 2006Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
I would shoot them. The primer sealant is surprisingly tough. I remember reading MIL-SPECS for primer sealant and they specified The sealant would hold up for weeks of immersion under one meter of water. I've routinely found ammo dropped or lost outdoors YEARS later and find they still fire.

In addition, the bullet lube on the LSWCHP bullet and case mouth further prevents powder contamination.

All the same, I would reserve them for slow fire only, carefully watch for squibs, and bring a wooden dowel rod and hammer to the range.
 
Posts: 795 | Location: west coast | Registered: 23 November 2007Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
Over the years, I have washed a bit more ammo than I care to admit, even some hand loads. They have all always fired. I might not carry them for PD rounds, but I would shoot them.

$6


A J-frame in the hand is worth two in the safe.
 
Posts: 30 | Location: Arkansas | Registered: 12 May 2008Reply With QuoteEdit or Delete MessageReport This Post
Member
Picture of Erich
Posted Hide Post
They'll shoot.

So, did that ding the heck out of those soft lead HPs or what? Smiler


Shot-placement is king. Adequate penetration is queen. Everything else is angels dancing on the heads of pins.
 
Posts: 6296 | Location: Albuquerque, New Mexico, USA | Registered: 04 January 2003Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
Funny...they stayed in the pocket during the wash cycle. To look at them now you wouldn't know the difference.
 
Posts: 667 | Location: Idaho Falls, Idaho | Registered: 20 April 2006Reply With QuoteEdit or Delete MessageReport This Post
OFT
Member
Posted Hide Post
Just run them through the dryer and everything should be okay.

No, No, No, don't. Just kidding. Big Grin


OFT/NRA LIFE MEMBER
 
Posts: 1649 | Location: Odessa Texas U.S.A. | Registered: 19 February 2004Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
Been there and done that at least three times. Replace the laundered loads with fresh and shoot those next time you're at the range. They will shoot...
 
Posts: 701 | Location: Allen, TX | Registered: 23 July 2001Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
I washed and dried five Glasers in .38 Spl. I think I still have the target I shot with them from my Model 37. All in the black at 25 yd. (Those were the old flat-faced "bullets." I believe that the later round ones were nowhere near as accurate.)
 
Posts: 4086 | Location: MA | Registered: 15 December 2002Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
When I realized they were being laundered I panicked thinking they could be in the dryer. I don't want to find out if they would go off from the heat!
 
Posts: 667 | Location: Idaho Falls, Idaho | Registered: 20 April 2006Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
dont' shoot them rapid fire, just in case, but i would be very surprised if they didn't shoot. i THINK the temp to cook off most lead azide or lead styphanate primers is about 350 f. i doubt a dryer gets that hot, but i wouldn't care to bet a new dryer on it.
 
Posts: 147 | Registered: 06 May 2008Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
I just pulled a 9mm 115 gr UMC JHP out of the dryer this morning. It went through three cycles (my dryer isn't very good and I was drying jeans and towels) on high heat. It didn't go off.
 
Posts: 6708 | Location: Virginia | Registered: 12 October 2003Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
"DRY CLEAN ONLY" Wink

- regards


------------------------------
"Our doubts are traitors, and make us lose the good we oft might win by fearing to attempt."
-Shakespere:"Measure for Measure"
 
Posts: 234 | Location: Seattle, WA | Registered: 18 April 2004Reply With QuoteEdit or Delete MessageReport This Post
Member
Picture of nitesite
Posted Hide Post
A couple years back I started a thread here about a Speer Gold Dot 230-gr .45ACP round that went thru the wash and dry cycles. I announced that I was going to repeat the wash/dry exposure a second time and wondered aloud if it would fire. Dozens of responses were mixed.

It went bang, exactly like all the others from the same box that never went thru either the water or being banged around in the heat.



NRA Member, Regular Army 1985-1993, Deputy Sheriff 1982-1985

"We conclude that the Second Amendment protects an individual right to keep and bear arms. That right existed prior to the formation of the new government under the Constitution and was premised on the private use of arms for activities such as hunting and self-defense, the latter being understood as resistance to either private lawlessness or the depredations of a tyrannical government." - U.S. Court of Appeals, D.C. Circuit, March 9, 2007

"...what is not debatable is that it is not the role of this Court to pronounce the Second Amendment extinct. We affirm the judgment of the Court of Appeals. It is so ordered."

--Justice Antonin Gregory Scalia, 26 June 2008, DC v. Heller



 
Posts: 3474 | Location: Morgan County Alabama - | Registered: 12 August 2002Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
quote:
Over the years, I have washed a bit more ammo than I care to admit, even some hand loads. They have all always fired. I might not carry them for PD rounds, but I would shoot them.


I've wash a few speed strips loaded with PD ammo over the years. Red Face

I just fire them at the next range trip.
Usually at the end of the handloads session.

It keeps me in the "Shoot what you carry" mode Big Grin.

No problems yet. However I am leary of carring them, after they have been washed, as PD rounds


.


A Survivial episode is just an unplanned adventure if you are prepared
 
Posts: 556 | Location: Southern Az Territory, Border County | Registered: 16 June 2004Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
Years ago I put a 7.62x39 round in the washer and dryer by mistake. It was hot as hell when it came out of the dryer. It shot just fine.

I allways wandered if it had been a .22 if it would have went off in the dryer????
 
Posts: 170 | Location: Lawrenceburg Indiana | Registered: 02 September 2007Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community Page 1 2  
 

smith-wessonforum.com    Main Page  Hop To Forum Categories  Ammunition    Washed a speed strip full of .38's...

© smith-wessonforum 2008