I had a question about my Omega Loveless Style Knife.
It was made by Hank Kubaiko, a superb craftsman- artesian.
Hank is now up in NE Ohio, I think.
The handle is micarta, don't know which steel.
Since this is a 'fighting' knife, it has a top or false edge.
The upper grind is like a chisel grind.
The bottom edge is a a semi- hollow point grind.
So when they meet in the middle, there is a 'spine.'
Once NM knife making ace Cody Wescott was looking at it.
He was comparing the spines. Loveless thought that a fighting knife should be slightly curved or I call it 'humped.'
So the side splines are slightly curved.
Cody was checking for even grind on both sides.
I say, is that hard to do? Cody says, you bet your *** it is!
And Hank did this with standard power tools.
He didn't have those fancy computer metal removal setups!
This may be the only one Hank ever made.
Omega Fighting Knife
Linear Mode
