Well looked forever for a kydex holster for Performance Center 629 snubbie, with no luck at all. I've been using a cheapie holster for 2 o'clock carry, but so thick! Well...decided to make my own. This is my first one, and I'm super happy with it!

Two thumbs up.

Thanks very much!

Nice. How about a few more photos? Did you mold it with a heat gun, or what?

Thanks! I'll take some more shots tomorrow! I put the sheet in the oven and used a touchless temp gun until it was exactly 300 degrees, then created a kydex taco around the gun. I prepped the gun first by taping a dowel that I cut to fit in between the from and rear sight to create a channel. Made the taco and then pressed it between two very stiff, thick foam pieces and put a board on top and sat in it for about 5 minutes. Then removed the gun, cut and sanded it into the shape I wanted with a Dremel. And added the clip and hardware.

Actually...enough to light for a few more photos:

Very nice job!

Thanks Dennis!