I picked up one of these pistol safes from Rual King and finally got around to throwing in some batteries to activate the finger lock but don't have the paperwork anymore. Anyone know how to set the code? I can't find any manual online at Bear Arms or Stackon dot com. A phone call to Rual King did not help either.

Thanks for reading. Didn't know where else to post this.

Try sending an email request to [email protected]

There is a small button like switch inside on the top. Push and hold it for a few seconds, I think it will beep, and it clears any code set. Enter your 3 digit code it will blink, enter again and it's set. If you hold down the last button until it blinks, you will set the motion detector on the safe. It will sound an alarm if the safe is moved. The motion detector is turned off when the safe code is used to open the safe. So you have to hold the last button each time after you open the safe if you want that part activated. The tamper alarm that goes off after 3 wrong codes is automatic. It will screech for about 2 minutes then quit. Once it's triggered, you have to wait until it stops on it's own. Mine is still on it's 1st set of batteries from 6 months ago and gets used daily. PM me if these instructions don't work as I am going from memory, and I will copy my instruction sheet and send it to you. I would do it now, but my printer scanner broke and the new one is coming this week.http://www****ralking.com/media/blfa_...Safe_BA094.pdf