Smith & Wesson Forum

Go Back   Smith & Wesson Forum > Smith & Wesson Revolvers > S&W Revolvers: 1980 to the Present
o

Notices

S&W Revolvers: 1980 to the Present All NON-PINNED Barrels, the L-Frames, and the New Era Revolvers


Reply
 
Thread Tools Display Modes
  #1  
Old 04-21-2012, 05:59 PM
686Magnum 686Magnum is offline
Banned
A little concerned A little concerned A little concerned A little concerned A little concerned  
Join Date: Apr 2012
Location: NW NC
Posts: 15
Likes: 1
Liked 3 Times in 2 Posts
Default A little concerned

I got a 686 no-dash not too long ago. I noticed when I spin the cylinder after I open it, there is some drag in one spot. I replaced the ejector rod thinking it may have a slight bend to it. Still does it. Could it be the ejector itself? Any ideas will be greatly appreciated...
Reply With Quote
  #2  
Old 04-21-2012, 06:26 PM
686Magnum 686Magnum is offline
Banned
A little concerned A little concerned A little concerned A little concerned A little concerned  
Join Date: Apr 2012
Location: NW NC
Posts: 15
Likes: 1
Liked 3 Times in 2 Posts
Default

ok. I took the cylinder assembly apart. Pulled the springs and ejector and the center pin. Put the cylinder back on the yoke and it spins very nicely. Put the extractor back in and still spins nicely. I really am left with the center pin and springs and I cant see the springs dragging this cylinder. Thoughts?

Last edited by 686Magnum; 04-21-2012 at 06:29 PM.
Reply With Quote
Reply

Tags
686, ejector, extractor

Thread Tools
Display Modes

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Should I be concerned? westernCOshieldM&P9mm Smith & Wesson M&P Pistols 24 03-29-2016 07:56 PM
I am concerned Biginge 2nd Amendment Forum 6 01-03-2013 11:24 PM
Should I be concerned about this? Rare Breed S&W Revolvers: 1980 to the Present 26 08-12-2012 05:35 PM
Concerned redlevel The Lounge 29 03-02-2012 04:21 PM
Should i be concerned? rock54 Smith & Wesson M&P Pistols 43 11-12-2011 10:03 AM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 12:03 PM.


Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)