|
|
08-12-2017, 05:14 PM
|
Member
|
|
|
Join Date: Aug 2017
Location: Houston
Posts: 183
Likes: 273
Liked 188 Times in 74 Posts
|
|
K frame part interchangeability
On other threads I've read that generally parts between k-frames are interchangeable. My question concerns the strain screw for the main spring. I read there was two lengths, one shorter and the other longer. I have not inspected yet, but it appears my K-22 has a short screw and the wife's K-38 a longer screw. Is there a reason for one over the other?
|
08-12-2017, 05:24 PM
|
|
Member
|
|
|
Join Date: Sep 2001
Location: Grinder's Switch, TN
Posts: 1,680
Likes: 1,440
Liked 1,444 Times in 664 Posts
|
|
Square butt guns should have screws of the same length. There may be minor variations, but shouldn't be a significant difference. Round butt models use a noticably shorter screw.
Mark
__________________
S&W Forum Member #721
|
The Following User Likes This Post:
|
|
08-12-2017, 05:32 PM
|
Member
|
|
|
Join Date: Aug 2017
Location: Houston
Posts: 183
Likes: 273
Liked 188 Times in 74 Posts
|
|
Quote:
Originally Posted by wheelgun610
Square butt guns should have screws of the same length. There may be minor variations, but shouldn't be a significant difference. Round butt models use a noticably shorter screw.
Mark
|
Both the K-22 and K-38 are square. I'll take pic later. Perhaps it was shortened.
|
08-12-2017, 05:51 PM
|
Member
|
|
|
Join Date: Aug 2017
Location: Houston
Posts: 183
Likes: 273
Liked 188 Times in 74 Posts
|
|
Both the K-22 and K-38 should be able to use the same main spring?
|
The Following User Likes This Post:
|
|
08-12-2017, 07:19 PM
|
Member
|
|
|
Join Date: Aug 2017
Location: Houston
Posts: 183
Likes: 273
Liked 188 Times in 74 Posts
|
|
It seems it was an optical illusion and differences in the thread and frame.
The older K-22 frame is a bit thinner and the screw thread portion is longer. The 1957 K-38 has a beefed up frame and the threaded portion is shorter. Both screws measure the same length.
|
The Following 2 Users Like Post:
|
|
08-12-2017, 07:50 PM
|
|
Member
|
|
|
Join Date: Sep 2001
Location: Grinder's Switch, TN
Posts: 1,680
Likes: 1,440
Liked 1,444 Times in 664 Posts
|
|
It's not uncommon to find S&W revolvers with shortened strain screws. That's one (incorrect) way some people reduce the trigger pull weight on them. The screw should be fully tightened in the frame for reliable primer ignition. Leaving the screw loose, or shortening it will cause light hammer strikes, often resulting in misfires.
Mark
__________________
S&W Forum Member #721
|
|
Posting Rules
|
|
|
|
|
All times are GMT -4. The time now is 02:24 AM.