Smith & Wesson Forum

Go Back   Smith & Wesson Forum > Smith & Wesson Revolvers > S&W Hand Ejectors: 1896 to 1961
o

Notices

S&W Hand Ejectors: 1896 to 1961 All 5-Screw & Vintage 4-Screw SWING-OUT Cylinder REVOLVERS, and the 35 Autos and 32 Autos


Reply
 
Thread Tools Display Modes
  #1  
Old 04-15-2018, 05:14 PM
scud553 scud553 is offline
Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Apr 2018
Posts: 2
Likes: 2
Liked 3 Times in 1 Post
Default Identifying model of S&W revolver

Hello everyone, today my dad just purchased a smith and Wesson at a gun show, and I am having some difficulty identifying what model and an age range for it. on the barrel it says 38 S&W Special, U.S. Service CTG'S. The other side of the barrel shows patent, which are kinda hard to read but the last one I believe is July 7 03. It has the fifth screw in the trigger guard. Serial number is 902xx. Any ideas on what model it is? I was thinking 1902, but also 1905, but honestly I have absolutely no clue so any help is appreciated! Thanks guys
Reply With Quote
The Following 3 Users Like Post:
  #2  
Old 04-15-2018, 05:24 PM
Alk8944's Avatar
Alk8944 Alk8944 is offline
Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Jan 2007
Location: Sandy Utah
Posts: 8,615
Likes: 1,554
Liked 8,602 Times in 3,450 Posts
Default

It is Model 1905 .38 Hand Ejector (Military & Police) 1st change made ca. 1907. The SN range for this model was 73251-146899 from 1906-1909.
__________________
Gunsmithing since 1961

Last edited by Alk8944; 04-15-2018 at 05:33 PM.
Reply With Quote
  #3  
Old 04-15-2018, 05:26 PM
merl67 merl67 is offline
SWCA Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Apr 2011
Location: Northern Middle Tennessee
Posts: 2,898
Likes: 3,413
Liked 4,084 Times in 1,449 Posts
Default

.38 Military and Police Model of 1905 1st Change made from 1906-1909 serial number range 73,251-146,899
Reply With Quote
The Following 3 Users Like Post:
  #4  
Old 04-15-2018, 05:35 PM
Absalom's Avatar
Absalom Absalom is offline
SWCA Member
Absent Comrade
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Jan 2014
Location: Oregon
Posts: 12,834
Likes: 10,103
Liked 27,995 Times in 8,452 Posts
Default

The finish seems to have largely turned into patina, but everything looks original. The stocks are the correct concave-top style for the decade. And it still has the “& US SERVICE CTG” on the barrel (a reference to the compatible .38 Colt) which was discontinued shortly afterwards.
Reply With Quote
The Following User Likes This Post:
  #5  
Old 04-15-2018, 05:36 PM
wheelgun610's Avatar
wheelgun610 wheelgun610 is offline
Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Sep 2001
Location: Grinder's Switch, TN
Posts: 1,681
Likes: 1,440
Liked 1,444 Times in 664 Posts
Default

Quote:
Originally Posted by merl67 View Post
.38 Military and Police Model of 1905 1st Change made from 1906-1909 serial number range 73,251-146,899
And I'd venture a guess that those stocks have been with that gun since it left the factory. At least, they're the correct style for an early 1905.

Mark
__________________
S&W Forum Member #721
Reply With Quote
  #6  
Old 04-15-2018, 05:43 PM
scud553 scud553 is offline
Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Apr 2018
Posts: 2
Likes: 2
Liked 3 Times in 1 Post
Default

Thanks for the quick replies guys! Very helpful, do you guys know if this would've been issued is either of the world wars? Any idea on value? No matter what its an awesome piece of history, and we only paid 189 for it.
Reply With Quote
  #7  
Old 04-15-2018, 05:56 PM
merl67 merl67 is offline
SWCA Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Apr 2011
Location: Northern Middle Tennessee
Posts: 2,898
Likes: 3,413
Liked 4,084 Times in 1,449 Posts
Default

You are welcome, it is not likely to have been issued or used in either of the wars. At $189.00 your dad did ok, not a steal but not a bad price either. The finish, or what is left of it is likely original if it were mine I would carefully remove the grips an give it a soak submerged in a mixture of one part acetone to one part automatic transmission fluid for a few days the using compressed air blow it out then put a good quality gun oil in all the openings working the action as you go wipe the exterior with the same the wipe excess off. Then clean the bore as you would normally. Modern 38 special can be shot in these no +P and cast lead bullets of the 158 grain weight will shoot best. You can get a letter that will tell you where and when it shipped.

Last edited by merl67; 04-15-2018 at 05:58 PM.
Reply With Quote
  #8  
Old 04-15-2018, 06:30 PM
Muley Gil Muley Gil is offline
US Veteran
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Feb 2005
Location: The SW Va Blue Ridge
Posts: 17,471
Likes: 88,955
Liked 24,774 Times in 8,480 Posts
Default

Welcome to the Forum.
__________________
John 3:16
WAR EAGLE!
Reply With Quote
The Following User Likes This Post:
  #9  
Old 04-15-2018, 07:11 PM
DWalt's Avatar
DWalt DWalt is offline
Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Dec 2009
Location: South Texas & San Antonio
Posts: 33,479
Likes: 236
Liked 28,938 Times in 14,012 Posts
Default

Based on my SN list 902xx likely shipped sometime in late 1906. The dual-caliber barrel stamping ended in the 1907-08 period, so the marking on your barrel is correct. The "U. S. Service Cartridge" is the .38 Long Colt, and indeed at that time it was the official revolver cartridge of the U. S. military. It is slightly shorter and less powerful than the later .38 S&W Special cartridge, so both .38 Special and .38 Long Colt can be used in any .38 Special revolver. You are not likely to see any boxes of .38 Long Colt ammunition on any dealers' shelves as it is essentially obsolete. Almost certainly, your revolver was not in official use or issued by the U. S. military. At that time they used Colt revolvers.

Last edited by DWalt; 04-15-2018 at 08:21 PM.
Reply With Quote
  #10  
Old 04-15-2018, 07:36 PM
JSR III's Avatar
JSR III JSR III is offline
SWCA Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Jun 2000
Location: Massachusetts USA
Posts: 9,575
Likes: 3,695
Liked 8,923 Times in 3,544 Posts
Default

Welcome to the forum. That is a neat old S&W and should be fun to shoot. Not a collectors item but a real working gun. To me any time you can buy a S&W for the price of an Air Soft gun you are doing OK. Be careful though, once you are bitten by the bug you will find yourself cruising pawn shops, gun shops and gun shows looking for more.
__________________
James Redfield
LM #497
Reply With Quote
  #11  
Old 04-16-2018, 07:32 AM
Wiregrassguy's Avatar
Wiregrassguy Wiregrassguy is offline
SWCA Member
Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver Identifying model of S&W revolver  
Join Date: Jul 2012
Location: AL Wiregrass
Posts: 7,201
Likes: 34,555
Liked 10,739 Times in 3,659 Posts
Default

Welcome to the forums from the Wiregrass!
__________________
Guy
SWHF #474 SWCA LM#2629
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Need help identifying what model revolver I have Hillyahhh S&W Revolvers: 1961 to 1980 9 05-17-2017 12:51 PM
Help identifying which model revolver I have chrliebrwn S&W Hand Ejectors: 1896 to 1961 6 08-15-2016 04:50 PM
Need help identifying age and model of this revolver SVTVinson S&W Hand Ejectors: 1896 to 1961 12 02-27-2015 07:01 AM
Help Identifying the model and age of a S & W revolver wenmass3 S&W Hand Ejectors: 1896 to 1961 11 08-13-2011 08:15 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 05:33 AM.


Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)