Smith & Wesson Forum

Advertise With Us Search
Go Back   Smith & Wesson Forum > Smith & Wesson Revolvers > S&W Revolvers: 1961 to 1980
Reload this Page Presentation case foam?
Forum Register

Notices

S&W Revolvers: 1961 to 1980 3-Screw PINNED Barrel SWING-OUT Cylinder Hand Ejectors WITH Model Numbers


Reply
 
Thread Tools Display Modes
  #1  
Old 03-10-2017, 10:47 PM
laytonj1 laytonj1 is offline
Member
Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam?  
Join Date: Aug 2007
Location: Alabama
Posts: 380
Likes: 5
Liked 278 Times in 75 Posts
Default Presentation case foam?
Is this piece of foam supposed to be with this case? It's about 3/8" thick and was in the lid behind the tray but I don't recall if it should be there or not.

Thanks,
Jim
Attached Images
File Type: jpg DSCN4007.jpg (80.7 KB, 68 views)
Last edited by laytonj1; 03-10-2017 at 10:52 PM.
Reply With Quote
  #2  
Old 03-11-2017, 09:41 AM
Doc44's Avatar
Doc44 Doc44 is offline
Moderator

Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam?  
Join Date: Dec 2002
Location: Indiana, USA
Posts: 9,402
Likes: 1,322
Liked 30,440 Times in 4,369 Posts
Default
The foam rubber goes behind the insert in the top.

Bill
Reply With Quote
  #3  
Old 03-11-2017, 05:50 PM
laytonj1 laytonj1 is offline
Member
Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam? Presentation case foam?  
Join Date: Aug 2007
Location: Alabama
Posts: 380
Likes: 5
Liked 278 Times in 75 Posts
Default
Thanks!

Jim
Reply With Quote
Reply

« Previous Thread | Next Thread »

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Presentation Case army-eod S&W Revolvers: 1961 to 1980 9 06-30-2017 09:01 AM
PRESENTATION CASE jjgunn57 WANTED to Buy 3 12-18-2013 10:40 PM
presentation case nicksfather WANTED to Buy 7 06-17-2010 01:17 PM
WTB Presentation Case for a Pre 29 Dave from Pa WANTED to Buy 9 08-09-2009 11:31 PM
686-3 2.5" forged or MIM inards?? jeep S&W Revolvers: 1980 to the Present 7 05-04-2009 06:19 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 09:21 PM.

Advertise with us - Contact Us - Smith & Wesson Forum - Top - Privacy Policy

Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)