Smith & Wesson Forum

Go Back   Smith & Wesson Forum > Smith & Wesson Revolvers > S&W Revolvers: 1961 to 1980
Reload this Page Barrel shank question.
Forum Register

Notices

S&W Revolvers: 1961 to 1980 3-Screw PINNED Barrel SWING-OUT Cylinder Hand Ejectors WITH Model Numbers


Reply
 
Thread Tools Display Modes
  #1  
Old 05-07-2017, 12:06 AM
rbrbrb6's Avatar
rbrbrb6 rbrbrb6 is offline
Member
Barrel shank question. Barrel shank question. Barrel shank question. Barrel shank question. Barrel shank question.  
Join Date: Nov 2012
Location: Western Oregon
Posts: 683
Likes: 340
Liked 2,402 Times in 429 Posts
Default Barrel shank question.
I hope one of you S&W aficionados can answer a question for me. Is the diameter and thread pitch the same on an N frame model 28 barrel as it is on a model 19 barrel?

Thank you for you help.
Reply With Quote
  #2  
Old 05-07-2017, 11:44 AM
Jim Watson Jim Watson is offline
Member
 
Join Date: Jun 2001
Location: Florence, Alabama, USA
Posts: 2,344
Likes: 40
Liked 1,393 Times in 771 Posts
Default
No.
K .540" 36 tpi
N .670" 36 tpi
Reply With Quote
The Following User Likes This Post:
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Chamfering outer rear edge of barrel shank keithherrington S&W-Smithing 10 11-04-2015 08:00 PM
barrel shank/thread? shooter93 S&W-Smithing 1 07-30-2012 09:18 PM

Powered by vBadvanced CMPS v3.2.3
smith-wessonforum.com tested by Norton Internet Security smith-wessonforum.com tested by McAfee Internet Security

All times are GMT -4. The time now is 02:28 PM.

Advertise with us - Contact Us - Smith & Wesson Forum - Top - Privacy Policy

Smith-WessonForum.com is not affiliated with Smith & Wesson Holding Corporation (NASDAQ Global Select: SWHC)