Quote:
Originally Posted by Joe scuba
Hello. I have an old Model 12. Does anyone know were I can get some grips for a square frame. This Model 12 has the narrow framed.
Regards
|
Depending on what you want this can be simple or difficult. If you just want stocks that fit and work start with standard K-Frame service stocks. Using 150-220 grit sandpaper simply lay this on a hard, flat surface and sand .040" off the back of the standard stocks. Use firm pressure and move the stocks front to rear as they are on the gun, not top to bottom. Check frequently and stop when the stocks match the grip frame of your Model 12. This will take only a few strokes so don't over do it! You will start seeing sanding marks on the stock washers when the correct amount of wood has been removed! Pressing
firmly is important as it helps prevent rounding of the back of the stocks!!!
If you want original factory stocks for a MODEL 12 through 12-3 this will be more difficult as Model 12 stocks are getting quite difficult to find especially round butt! The Model 12-4 has the same frame dimensions as the steel K Frames and uses the standard stocks.
I have owned five Model 12s and still have four. Two currently have stocks fit by sanding as I have described.